9 dBi Outdoor PoE Access Point

TEW-730APO (Version v1.0R)

Wireless N300 building-to-building networking (2.4 GHz)
Fat AP, Thin AP, Virtual Access Control (AC), and Virtual AC + Thin AP modes
Fat AP supports AP, WDS Bridge, WDS Repeater, Client, and CPE + AP modes
Built-in 9 dBi directional antenna
IP55 rated housing

TRENDnet's 9 dBi Outdoor PoE Access Point, model TEW-730APO, provides wireless N300 (2.4 GHz) building-to-building connectivity. It supports Fat AP, Thin AP, Virtual Access Control (controls compatible Thin AP devices), and Virtual AC + Thin AP modes. Fat AP mode supports a variety of installation scenarios with Access Point (AP), WDS Bridge, WDS Repeater, Client, and CPE + AP modes. The rugged IP55 rated TEW-730APO comes with a proprietary PoE injector and a pole mounting kit.

Building-to-Building

An integrated 9 dBi directional antenna, WiFi N300, and an included PoE injector facilitate building-to-building networking.

Installation Flexibility

A variety of installation scenarios are supported with Access Point (AP), WDS Bridge, WDS Repeater, Client, and CPE + AP modes.

Outdoor Ready

Built for protected outdoor locations with an IP55 weather rating and an operating temperature range of -20 – 70 °C (-4 – 158 °F).

Multiple views of the 9 dBi Outdoor PoE Access Point TEW-730APO. On the left is a left side view with a label for LED Indicators. In the center is the front bottom view with labels for Ethernet Port and Reset Button. On the right is the bottom view of the included PoE injector with labels for Ethernet port and Power port.

Illustration of how 9 dBi Outdoor PoE Access Point TEW-730APO is used. On the left, an access point is attached on top of two buildings facing each other with a wireless signal labeled Building-to-Building (WDS Mode). The access point on the right has an orange line going into a PoE Injector located in the server room. On the right, it shows an antenna and a wireless access point on top of a building sending a wireless signal to each other labeled Wireless Internet Service (CPE Mode).

Multi-Mode Support

Supports Fat AP, Thin AP, Virtual Access Control (controls compatible Thin AP devices), and Virtual AC + Thin AP modes

Fat AP Mode

Fat AP mode supports a variety of installation scenarios with Access Point (AP), WDS Bridge, WDS Repeater, Client, and CPE + AP modes

Thin AP Mode

Thin AP mode supports management of the TEW-730APO by another device (such as another TEW-730APO set to Virtual Access Control) and Thin AP supports Access Point (AP) mode

Virtual Access Control (AC) Mode

Virtual Access Control mode manages other compatible access points set to Thin AP

Wireless N300 (2.4 GHz)

Compliant with 802.11n/g/b technology (2.4 GHz spectrum) with data rates up to 300 Mbps

Directional Antenna

Built in 9 dBi directional antenna

Outdoor Rated

Durable enclosure with an IP55 outdoor weather rating

Power over Ethernet (PoE)

Comes with a PoE injector (non-802.3af compliant)

Logs

Real time logs and statistics help trouble shooting

Encrypted Wireless

Support for wireless encryption of up to WPA2

Compatibility

Compatible with 2.4 GHz legacy wireless devices

Mounting Hardware

Pole mounting hardware included

Standards	IEEE 802.3 IEEE 802.3u IEEE 802.1d IEEE 802.1p IEEE 802.1Q IEEE 802.1X IEEE 802.11f IEEE 802.11b IEEE 802.11g IEEE 802.11n (up to 300 Mbps)
Hardware Interface	1 x 10/100 Mbps (proprietary PoE) port** Reset button LED indicators Grounding point
Special Features	IP55 weather rated 802.1Q VLAN assignment per SSID
Access Control	Wireless encryption: WEP, WPA/WPA2-PSK, WPA/WPA2-RADIUS Firewall (CPE Mode): NAT, Port Forwarding, DMZ Host Access Controls: MAC, IP Filter, Port Filter, Per-SSID client limiting 802.1Q VLAN
QoS	WMM Traffic Shaping
Operation Modes	Fat AP Thin AP Virtual AC Virtual AC + Thin AP
FAT AP Modes	Access Point (AP) Client (Client + AP) CPE (Client + Bridge) WDS Bridge WDS Repeater
SSID	Up to 8 SSIDs
Internet Connection Types (CPE mode)	Dynamic IP (DHCP) Static IP (Fixed) PPPoE (Dynamic IP)
Management/Monitoring	Local/remote web based management (HTTP, HTTPS) Local/remote CLI based management (Telnet, SSH) SNMP v2/v3 CPE Management Upgrade firmware Backup/restore configuration Event logging Syslog Reboot Restore to factory defaults Ping test Ping Watchdog Trace Route STP STP forward delay Traffic Shaping MAC based access control
Frequency	FCC: 2.412 – 2.462 GHz ETSI: 2.412 – 2.472 GHz
Wireless Channels	FCC: 1 – 11 ETSI: 1 – 13
Modulation	802.11b: DBPK, DQPSK, CCK with DSSS 802.11g/n: BPSK, QPSK, 16-QAM, 64-QAM with OFDM 9 dBi internal directional antenna
Wireless Output Power/Receiving Sensitivity	802.11b: FCC/ETSI: FCC: 24 dBm (max.), ETSI: 11 dBm (max.)/ -85 dBm (typical) @ 11 Mbps 802.11g: FCC/ETSI: FCC: 22 dBm (max.), ETSI: 11 dBm (max.)/ -70 dBm (typical) @ 54 Mbps 802.11n: FCC/ETSI: FCC: 20.5 dBm (max.), ETSI: 9 dBm (max.)/ -62 dBm (typical) @ 300 Mbps
EIRP	FCC: up to 33 dBm (with built in 9 dBi antenna) ETSI: up to 20 dBm (with built in 9 dBi antenna)
Power	Input: 100 – 220 V, 50 – 60 Hz, 0.6 A Output: 24 V / 1 A Consumption: 12 Watts Max.
Operating Temperature	-20 – 70° C (-4 – 158° F)
Operating Humidity	Max. 95 % non-condensing
Certifications	CE FCC
Dimensions	205 x 64 x 61 mm (8.1 x 2.5 x 2.4 in.)
Weight	0.8 kg (1.8 lbs.)
Warranty	3 year limited

PACKAGE CONTENTS

TEW-730APO
CD-ROM (User's Guide)
Quick Installation Guide
Poll mounting hardware
Proprietary PoE injector (24 V, 1 A)
Power Cord
Grounding wire

* Effective wireless coverage may vary depending on the wireless device's output power, antenna gain, antenna align-ment, receiving sensitivity, and radio interference. Additionally environmental factors such as weather conditions, physical obstacles, and other considerations may affect performance. For optimal results, we recommended consulting a professional installer for site survey, safety precautions, and proper installation.
**Recommended max. PoE cable length of 70 m

All references to speed are for comparison purposes only. Product specifications, size, and shape are subject to change without notice, and actual product appearance may differ from that depicted herein.