18-Port Gigabit PoE+ Smart Surveillance Switch

TPE-3018LS   (Version v1.0R)

  • 16 x Gigabit PoE+ ports
  • 2 x Shared Gigabit ports (RJ-45 or SFP)
  • 220W PoE power budget
  • Easy-to-use web-based management interface
  • Supports IPv6, LACP, VLAN, QoS, and IGMP Snooping
  • Extend PoE+ signal up to 656 ft./200m at 10Mbps
  • Front panel 4-digit LED display provides PoE power statistics
  • Surveillance mode GUI for simplified configuration and network monitoring
  • Device discovery for ONVIF compliant IP cameras and NVRs
  • Upload building floorplans to create an E-map of surveillance devices
  • Change IP camera IP address settings
  • Upgrade IP camera firmware
  • Change IP camera administrator user name and password
  • Bandwidth control per port
  • 802.1Q, MAC, Surveillance, and Voice VLAN support
  • IEEE 802.1p QoS with queue scheduling support
  • Smart Fan
  • 36Gbps switching capacity
  • NDAA / TAA compliant (U.S. and Canada only)
  • Lifetime Warranty*
NDAA/TAA Compliant

Firmware

Firmware

Model: TPE-3018LS
H/W Version: v1.xR
Firmware Version: 1.01.31
Release Date: 4/2021
Note:

  • Fixed intermittent reboot issue due to high CPU utilization.
  • Set password minimum character limit to 8 for ONVIF device authentication and authorization.
  • Changed default PD alive check reboot time default to 180 seconds.
  • Changed default web idle timeout to 30 minutes.
  • Fixed issue losing ONVIF device authentication and authorization status after switch reboot or ONVIF device reboot.
  • Added non-digest method to address authenticatication and authorization compatiblity with some ONVIF devices.

Filename: FW_TPE-3018LS_v1(1.01.31).zip
SHA-1 Checksum: 03CC5FA41FBD9C93D11E1074725E139AD0730E02
Date: 2/7/2022
File Size: 7.95 MB
Download

Other

MIB
Version: 1.00
Release Date: 11/2020
Note:
  • Initial Release

Filename: MIB_TPE-3018LS_v1(1.00).zip
Date: 11/1/2020
File Size: 88.71 KB
Download

Datasheet

Datasheet (English)
Filename: EN_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.50 MB
Download Email
Datasheet (Français)
Filename: FR_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.51 MB
Download Email
Datasheet (Deutsch)
Filename: GE_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.51 MB
Download Email
Datasheet (Português)
Filename: PO_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.50 MB
Download Email
Datasheet (Español)
Filename: SP_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.49 MB
Download Email
Datasheet (Pусский)
Filename: RU_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.52 MB
Download Email
Datasheet (Italiano)
Filename: IT_datasheet_TPE-3018LS_(v1.0R).pdf
Date: 9/23/2020
File Size: 1.50 MB
Download Email

User's Guide

User's Guide
Filename: UG_TPE-3012LS_TPE-3018LS(v1).pdf
Date: 11/12/2020
File Size: 5.65 MB
Download

Product Images

PNG Image
File Size: : 2.81 MB
Date: : 9/23/2020
Download
PNG Image
File Size: : 2.57 MB
Date: : 9/23/2020
Download
PNG Image
File Size: : 2.28 MB
Date: : 9/23/2020
Download
ROHS compliant WEEE crossed-out bin symbol.
Standards
  • IEEE 802.1d
  • IEEE 802.1p
  • IEEE 802.1Q
  • IEEE 802.1s
  • IEEE 802.1w
  • IEEE 802.1X
  • IEEE 802.1ab
  • IEEE 802.3
  • IEEE 802.3u
  • IEEE 802.3x
  • IEEE 802.3z
  • IEEE 802.3ab
  • IEEE 802.3ad
  • IEEE 802.3af
  • IEEE 802.3at
  • IEEE 802.3az
Device Interface
  • 16 x Gigabit PoE+ ports
  • 2 x Shared Gigabit ports (RJ-45 or SFP (100/1000Mbps))
  • LED indicators
  • PoE power status LED display (total power budget, available power, consumption per port)
Data Transfer Rate
  • Ethernet: 10Mbps (half duplex), 20Mbps (full duplex)
  • Fast Ethernet: 100Mbps (half duplex), 200Mbps (full duplex)
  • Gigabit Ethernet: 2000Mbps (full duplex)
Performance
  • Switch fabric: 36Gbps
  • RAM buffer: 512KB
  • MAC address table: 8K entries
  • Jumbo Frames: 10KB
  • Forwarding mode: store and forward
  • Forwarding rate: 26.7Mpps (64-byte packet size)
Management
  • HTTP / HTTPS web-based GUI – Standard or Surveillance Mode
  • CLI command line interface (Telnet / SSHv2)
  • SNMP v1, v2c, v3
  • IPv4/IPv6 support
  • Multiple administrator or user accounts
  • Dynamic/static unicast MAC address table
  • Enable or disable 802.3az power saving per port
  • Syslog
  • System message logging severity levels
  • Port mirroring (transmit, receive, one-to-one, many-to-one)
  • ICMPv4/ICMPv6
  • Traceroute
  • LLDP
  • Cable diagnostics test
  • SFP DDM (Digital-diagnostic-monitoring)
  • UDLD (UniDirectional Link Detection)
  • Port error disabled/Errdisable state
  • Ping watchdog
MIB
  • RMON MIB RFC 1271
  • IPV4 MIB RFC 1213 (read only)
  • SNMP MIB RFC 3415
Spanning Tree
  • STP (spanning tree)
  • RSTP (rapid spanning tree)
  • MSTP (multiple spanning tree)
Link Aggregation
  • Static link aggregation and dynamic LACP (Up to 8 groups)
Quality of Service (QoS)
  • 802.1p Class of Service (CoS)
  • DSCP (Differentiated Services Code Point)
  • Bandwidth limit per port
  • Queue Scheduling: strict priority (SP), weighted round robin (WRR)
VLAN
  • Multiple management VLAN assignment
  • 802.1Q Tagged VLAN
  • MAC-based VLAN
  • Surveillance VLAN
  • Voice VLAN
  • Up to 256 VLAN groups, ID Range 1-4094
Multicast
  • IGMP Snooping v2/v3
  • IGMP immediate/fast leave
  • IGMP querier
  • Dynamic/static multicast MAC address table
  • MVR (Multicast VLAN registration)
  • Up to 1K multicast entries
Access Control
  • 802.1X port-based authentication (Local user database, RADIUS, Guest VLAN)
  • DHCP Snooping / Option 82
  • Loopback detection
  • Denial of Service (DoS) prevention
  • Storm control (broadcast, unknown multicast, unknown unicast, min: 16Kbps)
  • Head-of-line (HoL) blocking prevention
  • IP Source Guard / IP-MAC-Port-VLAN binding
  • Protected ports
  • Port Security/MAC address learning restriction
  • Access Control List (ACL)
  • MAC Address (VLAN ID, EtherType, 802.1p)
  • IPv4 (IP Protocol, TCP/UDP Port, 802.1p, DSCP, TCP flag, ICMP type, ICMP code)
  • Surveillance Mode (ONVIF)
  • Surveillance mode GUI for simplified configuration and network monitoring
  • Device discovery for ONVIF compliant devices such as IP cameras or NVRs
  • Upload virtual maps
  • Change IP camera IP address settings
  • Upgrade IP camera firmware
  • Change IP camera administrator user name and password
PoE
  • PoE budget: 220W
  • 802.3at: up to 30W per port (ports 1-16)
  • PoE Mode A: Pins 1,2 and pins 3,6 for power
  • PoE power scheduling
  • PD alive check
  • Over current/short circuit protection
Power
  • Input: 100 – 240V AC, 50 – 60Hz, internal power supply
  • Max. consumption: 14W (No PoE load)
Surge Protection
  • 6kV (Ports 17 & 18)
Fan/Acoustics
  • Quantity: 1 (Hot swappable)
  • Noise Level: 60.1 dBA (max.)
MTBF
  • 331,516 hours
Operating Temperature
  • 0 – 40°C (32 – 104°F)
Operating Humidity
  • Max. 90% non-condensing
Dimensions
  • 440 x 195 x 44.45mm (17.3 x 9.8 x 1.74 in.)
  • Rack mountable 1U height
Weight
  • 2.93kg (6.45 lbs.)
Certifications
  • CE
  • FCC
  • ETL
Warranty

PACKAGE CONTENTS
  • TPE-3018LS
  • Quick Installation Guide
  • Power cord (1.5m/5 ft.)
  • Rack mount kit

All references to speed are for comparison purposes only. Product specifications, size, and shape are subject to change without notice, and actual product appearance may differ from that depicted herein.