Can I save video to my Network Storage Device?
FAQ ID: 1992 Updated: 7/14/2009 6:46:51 PM
Log into the camera and click on Setup then click on Event Server>Network Storage on the left hand side. Enter your Samba server information here.
After applying the Samba server information click on Event Config on the left hand side. You have three options, Motion Detection, Scheduled uploading and GPIO trigger. You also have Schedule profiles where you can customize schedules.
- Schedule Profile:< Click on Add and define a name for the profile. After you name the profile, click on it to define the schedule. >
- Motion Detect Trigger: Check to enable it, choose your profile and check Record to Network Storage. (Note: The default schedule is "always". You can set custom schedules under Event Config>Schedule Profile.
- Schedule Trigger: Under Network Storage Schedule check to enable it, select your profile and define the interval that the camera will record. (Note: The default schedule is "always". You can set custom schedules under Event Config>Schedule Profile. The recording time is defined under Event Config>General. The recording interval under Event Config>General must be lower than the interval set under Event Config>Schedule Trigger.)
- GPIO Trigger: Check to enable it and then place a check mark in Record to Network Storage. (Note: The default schedule is "always". You can set custom schedules under Event Config>Schedule Profile.
Related FAQs:
- How to setup the Internet Camera for Remote Viewing over the Internet
- How can I view the TV-IP422 (w) remotely if it’s behind a router?
- In bright lighting conditions the camera displays a washed out image. Is there anything I can change to improve the image?
- What is the default IP address of my TV-IP422 (w)?
- How do I reset my TV-IP422 (w) back to factory defaults?
Attachments:
No attachments found.