TRENDnet TEW-633GR EWC Router | Basic / Network Settings

•	Wizard
•	Internet
•	Wireless
•	Network Settings

Network Settings

Use this section to configure the internal network settings of your router and also to configure the built-in DHCP Server to assign IP addresses to the computers on your network. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again.

WAN Port Mode

WAN Port Mode :

Router Mode Bridge Mode

Router Settings

Use this section to configure the internal network settings of your router. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again.

Router IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server :
Secondary DNS Server :
Local Domain Name:	(optional)
Enable DNS Relay:

RIP (Routing Information Protocol)

Use this section to configure RIP for automatic management of routes.

Enable RIP:
RIP Operating mode :	V1 V2 Broadcast V2 Multicast
Router Metric
Act as default router:
Accept WAN updates:
RIP Password:
Confirm RIP Password:

DHCP Server Settings

Use this section to configure the built-in DHCP Server to assign IP addresses to the computers on your network.

Enable DHCP Server:
DHCP IP Address Range:	to
DHCP Lease Time:	(minutes)
Always broadcast:	(compatibility for some DHCP Clients)
NetBIOS announcement:
Learn NetBIOS from WAN:
NetBIOS Scope:	(optional)
NetBIOS node type :	Broadcast only (use when no WINS servers configured) Point-to-Point (no broadcast) Mixed-mode (Broadcast then Point-to-Point) Hybrid (Point-to-Point then Broadcast)
Primary WINS IP Address:
Secondary WINS IP Address:

DHCP Reservations List

Enable	Computer Name	MAC Address	IP Address

Configuration Warnings