Overview Please ensure you have followed the quick installation guide and have the camera setup and accessible on your home/office network. The following instructions are going to outline how to make a SecurView camera accessible over the Internet. We will start by assigning a unique static IP ad...

NOTE: The following example is using a TEW-432BRP wireless router with the TV-IP400 (w). In this example, we have change the IP address of the camera to 192.168.1.20 and the default gateway as 192.168.1.1 Step 1 Log into the router by entering its IP address into a browser. The default IP a...

From the web-based interface when viewing the image through Java or Active X the controls are on the left hand side. You can also control the pan and tilt through the IPView SE application. ...

Step 1 Open your web browser and type the IP address of the TV-IP400(w) in the address bar. The default IP address is 192.168.0.20. Step 2 Click System Administration. Step 3 Click Configuration at the top of the page then click Wireless on the left hand side. Enter in your wireless...

Step 1 Open your web browser and type the IP address of the TV-IP400(w) in the address bar. The default IP address is 192.168.0.20. Step 2 Click System Administration. Step 3 Click Configuration at the top of the page then click System on the left hand side. Enter in the desired use...

Step 1 Locate the reset button on the back of the unit Step 2 Disconnect the power supply. Step 3 Press and hold in the reset button. Step 4 While holding in the reset button; reconnect the power supply. Step 5 Continue to hold in the reset button for approximately 10 seconds to ...

Step 1 Open your web browser and type the IP address of the TV-IP400(w) in the address bar. The default IP address is 192.168.0.20. Step 2 Click on Configuration at the top of the page then click on User on the left hand side. Enable the Access Control and enter in the desired usernames an...

Internet Explorer (5.0 or above) or Netscape Navigator (6.0 or above)

Step 1 Start the IPView SE application by clicking on Start>All Programs>IPView SE>IPView SE. Step 2 Click on Camera 1. Step 3 The IPView SE application will detect your camera. Highlight the camera by single left clicking on it and then click Add. ...

Step 1 Open your web browser and type the IP address of the TV-IP400(w) in the address bar. The default IP address is 192.168.0.20. Step 2 Click on Configuration at the top of the page then click on Upload on the left hand side. Enter your FTP server information and click Save. Note: Fo...

Step 1 Open the IPView SE software. Step 2 Click on the Camera Configure button then click the Motion Settings button for additional settings. Step 3 Enter the information in the appropriate fields and click OK. ...

No, it does not support Power over Ethernet

Step 1 Click on the Camera Configure button then click the Update Firmware button for additional settings. Step 2 Click Browse and locate the firmware file then click Update. ...

Step 1 Open the IPView SE software. Step 2 Click on the System Configuration button to configure options for recording. Step 3 Click on the Camera Configure button then click the Motion Settings button for additional settings. Step 5 Once the unit is set to the desired config...

Each camera behind a firewall or router will need to forward the port that the camera is using. The default port is 80. If you are installing multiple cameras you must change the port on the additional cameras. Step 1 Open your web browser and type the IP address of the TV-IP400(w) in the ...

The default IP address is 192.168.0.20.

Open your web browser and type the IP address of the TV-IP400(w) in the address bar. The default IP address is 192.168.0.20....